30 Mil Digimag Matte Vinyl 24.375" x 50' Magnet Roll

• Before applying, test all inks and paints used on the magnet for adhesion and solvent compatibility.
• Affix to smooth, flat, or gently curved metallic surfaces.
• Make sure the entire magnet is flat against the metal surface. Do not place over protrusions (molding, decals, pin striping, etc.) or concave areas. There must be NO air pockets.
• The magnet should be at a room temperature of 60 degrees F (16 degrees C) or above to achieve the best results.
• Do not apply a magnet curled with the magnet side out. The magnet may not attach properly to the metallic surface, resulting in lifted corners or air gaps, weakening its holding strength. Follow the instructions for Storing Flexible Magnets.
• If you place the magnet in the wrong position, completely remove it from the surface and reaffix it. Lift at sides and not at corners to remove. Do not pull the magnet across the surface, or it may stretch due to the resistance caused by the high magnetic strength.
• Do NOT use on horizontal metal surfaces exposed to direct sunlight (such as automobile hoods), temperatures exceeding 160 degrees F (71 degrees C), or temperatures below -15 degrees F (-26 degrees C). Exposure to cold weather will make the magnet more brittle, so use caution when handling it.
• Long-term use on surfaces frequently exposed to sunlight (such as vehicles) can result in uneven surface fading because the magnet-covered area is shielded from ultraviolet rays.
• Do NOT use it on non-metallic body fillers, simulated wood grain siding, and repainted surfaces.

NOTE: Doors and panels on some vehicles are not made of steel. This product will not work on aluminum and plastic surfaces.

• We recommend rounded corners for magnetic vehicle signage.

• Remove the magnet at regular intervals to guard against moisture and dirt buildup between the magnet and the metal surface (particularly on outdoor applications). Clean the magnet and metal surface with mild detergent; wipe with a soft cloth or air-dry. (For vehicle-mounted signs, remove and clean DAILY.)
• After waxing and polishing, allow two days for wax to cure before applying magnets.

Magnum Magnetics, we produced in the United States at two Ohio manufacturing facilities.